Print Page | Close Window

Belt slipping

Printed From: Sailrite Enterprises, Inc.
Category: Sewing Machines
Forum Name: Home Sewing Machines
Forum Discription: Using home sewing machines
URL: http://forum.sailrite.com/forum_posts.asp?TID=267
Printed Date: 24 October 2021 at 1:58am


Topic: Belt slipping
Posted By: rcolson
Subject: Belt slipping
Date Posted: 12 June 2007 at 5:28pm
I have had my LSZ 1 for about 5 years with no issues.  Recently when I need to sew through more than 2 layers the needle stops and the belt slips with no pressure to get through the fabric.  Do I need to replace the current belt or make some kind of adjustment?
 
Robin



Replies:
Posted By: w1ndfall
Date Posted: 13 June 2007 at 12:16am

Do you have a Monster Wheel attached?  If so, try torquing down in the two set screws 90 degrees out under the belt.  The needle bar assembly will move up and down all the time, even when you are winding a bobbhin, but you will eliminate the issue caused by clutch slippage.  If you do not have the Monster Wheel, just tighten the clutch.

 
I hope that this helps.
 
Best regards,
Dan Smith
Annapolis Store Manager



Print Page | Close Window