Print Page | Close Window

Juki 1508n Table

Printed From: Sailrite Enterprises, Inc.
Category: Sewing Machines
Forum Name: Industrial Sewing Machines
Forum Discription: The use and maintenance of industrial sewing machines
URL: http://forum.sailrite.com/forum_posts.asp?TID=3667
Printed Date: 18 January 2020 at 7:53pm


Topic: Juki 1508n Table
Posted By: aoconstruction
Subject: Juki 1508n Table
Date Posted: 07 February 2019 at 9:18am
Will the table and servo motor that comes with the sailrite fabricator also accomadate a juki sewing machine? Thinking about setting up a a second station and have a friend that wants to give me a juki that no longer uses it.

             Thanks Alan




Replies:
Posted By: MattGrant
Date Posted: 07 February 2019 at 9:22am
The Workhorse motor and the table legs would be fine. The table top could be different though if the Juki is not an auto lubricating model. But we likely have a top that would work. I just need to know the Juki model number.

matt@sailrite.com


-------------
Best Regards,
Matt Grant
Sailrite


Posted By: Tejas
Date Posted: 08 February 2019 at 8:37am
The cut-out for my Juki 1508N is about 7" x 20 1/2".

-------------
Beneteau First 36.7

Juki LU-1508N
Bernina 217N with CAM Reader
Singer 99 with hand crank


Posted By: MattGrant
Date Posted: 08 February 2019 at 8:53am
That is a bit different than the Fabricator which is 7.25" by 18.875". The other issue is how the oil try, if it exists, drops into the cutout. When the oil tray is integrated into the rubber corner pads the corner supports of the wooden table must be deeper. And typically the forward pads are oval in shape which requires a special router cut at those corners. The Fabricator is setup like this. If the machine does not have an oil pump then it is more common for the corner supports to just fit into radius shaped corners and the wooden corner supports are not so deep.

Hope this helps. 


-------------
Best Regards,
Matt Grant
Sailrite



Print Page | Close Window